WiseFab - Toyota 86 / BRZ Front V2 Lock Kit for Front Rack (WF8601)

• 65+ degrees of usable steering angle
• Adjustable Ackermann — tune toward positive or negative Ackermann in minutes without changing alignment (washers included)
• High-strength steel knuckles and control arms, machined after welding
• CrMo rod ends and spherical bearings instead of OEM bushings
• Lowered ball joint raises the front roll center on a lowered car, allowing the front sway bar to be removed
• Good camber control and minimal bump steer through the whole steering range
• Consistent, predictable self-aligning torque at high lock

Kit contents

• Pre-set lower control arms
• Knuckles with hardware
• Assembled tie rods
• Pre-set coilover camber plates
• Front-position rack relocation kit
• Crossmember supports
• Installation guide

Installation notes

BMW and Lexus steering rack attachments and crossmember inserts are included. Some DIY cutting and welding of the crossmember is required — follow the installation manual. Coilovers required. Wider fenders or flares may be needed depending on wheel width and offset; 18" wheels recommended. On the BRZ, tires no larger than about 605mm diameter are recommended.

Fitment

Toyota 86 / Scion FR-S / Subaru BRZ / GR86.

Ships from the U.S. Shipping and sales tax (where applicable) are calculated at checkout.